Industrial flooring "Beijing" 10 & 15 mm

The floor installer glues them on the subfloor, sands off the tape, fills the gaps and finishes the surface. Being made of such small strips, the floor is very stable – making it the perfect solution for application on floor heating.

installation summary (full version available on www.crownbamboo.eu)

• Check room climate conditions (room temp. 18-20°C, air humidity 50-65%).

• Check subfloor: this should be flat/clean/stable and should not exceed the maximum allowed moisture content (for example 1.8% for sand cement).

• The floor should be fully glued (for glue details see full version of installation instruction).

• Elastic adhesive systems like 1-component Polyurethane or silan type of adhesives only can be used, when:

• Shear strength Ts > 1.4 N/mm² (3 days balanced at 23 degrees Celsius/50% Air Humidity)

• Shear elongation y >=0.5 (3 days balanced at 23 degrees Celsius/50% Air Humidity) Please ask your glue supplier for more information.

• After the glue has hardened, the floor can be sanded, filled (with a mixture of sanding dust and floor filler) and finished (with floor lacquer or oil).

• This floor type can be installed – under certain conditions – on warm water floor heating. See “Crownbamboo flooring and floor heating“.

• After installation: make sure proper cleaning and maintenance is done, fitting to the chosen finish.

• Attention: the width of the individual bamboo strips can vary between approx. 4 and 8mm (High Density 13-14mm). MOSO guarantees that within 1 delivery the variation in strip width is limited.